![]() ![]() ![]() Then move the group in the direction you need to get it in the bullseye. Shoot 4 or 5 at the same place and notice where they hit. It may take a shot or two for the scope to finish adjusting so don’t chase 1 shot here and there with adjustments.At that range, 10 to 15 feet, you’ll need to turn the adjustment knobs 1/2 to full turns to see any change in impact. Adjust the scope to get the pellet hitting about near the target.To begin sighting, start at 10 or 15 feet and shoot into a safe target like a pellet trap or some other device that will stop the pellet and prevent ricochet.Just bring them fairly snug on all four screws. Once “square,” tighten down the top rings but do not over tighten.not at an angle, and adjust for a comfortable eye relief. Once replaced, hold the rifle to your shoulder and alight the scope to be “square” up and down / left to right, i.e. Replace the rings but do not tighten them all the way down.Remove the top half of the scope rings from the mount(s) and install the scope. ![]() Be sure to align the stop pin with the hole in the top of the receiver of the gun near the back if so equipped. Quick Scope Installation and Sighting Guide Instructions Quick Scope Installation and Sighting Guide
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. Archives
June 2023
Categories |